Filter
Top Products
12 Dehumidifier
Operating Instructions
Water level
control switch
The dehumidifier will turn off automatically when the bucket is full,
or when the bucket is removed or not replaced in the proper
position.
The bucket must be replaced in the proper position for the
dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the proper
position.
1
. Empty the bucket manually.
2
. Attach a length of garden hose to the threaded drain hose
connection to carry water to the drain.
When the bucket is full, pull out by
grasping the handle and empty it
into a large sink or tub and then
replace it properly.
Do not remove while
operating the dehumidifier.
It can cause water to drop on the
base pan or the floor.
Empty the bucket when the indicator
light turns on.
It is advisable to carry the
bucket by supporting it from the
bottom as well as by the handle.
Carrying by only the handle may
cause the handle or bucket cover to
break.
1. Remove the drain-hole cover.
2. Connect a garden hose to the
threaded drain hose connector.
3. Push hose connector tightly to
the drain-hole on Rear Grille.
The hose attachment will
accept a standard garden hose
fitting.
Do not over tighten the hose when
connecting it to the hose connector,
use a rubber washer and tighten by
hand firmly without stripping the
plastic threads.
When being attached to hose
connector drain hose connection,
do not bend or kink the hose.
The hose should lie flat from the
dehumidifier to the drain.
NOTICE
NOTICE
NOTICE
Automatic shut off
Disposing of collected water
HOSE-CONNECTOR
DRAIN HOLE COVER
INSERT
TAKE OUT