Filter
Top Products
20 Multi type Air Conditioner
Installation
■ Sticking the installation guide map and
fixing Indoor unit
■ Drill a hole in the wall
• Drill the piping hole with a ø50mm hole core drill. Drill
the piping hole at either the right or the left with the hole
slightly slanted to the outdoor side.
Plastic anchors
INSTALLATION GUIDE MAP
10m
m
INSTALLATION GU
INSTAIIATION G
UIDE MAP
INSTALLATION GUIDE MAP
1. Put an Installation Guide Map on the desired
surface.
2. Make a hole with diameter of 6mm and depth of
30-35mm when piercing a screw point.
3. Drive the fore plastic anchors into drilled points.
4. Hang the hole of product at the upper screws.
(In this time, Remove the map)
(Falling attention)
5. Check the fixed product with light power.
6. Look at suited horizon by horizontal meter on
the horizontal setting line, and Fix lightly the
map by adhesive tape.
7. Drill the piercing part for connecting pipe as
diameter 50mm. (In case of piercing rear surface)
Refer to No. 5 on this page when making a hole in the wall.
8. First, Drive the two points of the upper parts by
screws. (Leave 10mm for hanging product)
9. Drive the lower parts after facing the hole of
product with plastic anchors, and fix completely
the upper screws.
In case of nothing wrong in the matter,
connect the pipe and the wire.
(Installation manual reference)
Horizontality
IN
S
T
A
L
L
A
T
IO
N
G
U
ID
E
M
A
P
Plastic anchors
IN
S
T
A
L
L
A
T
IO
N
G
U
ID
E
M
A
P
Hanger hole
(Rear side of
product)
5-7mm
(0.2~0.3")
Indoor
WALL
Outdoor