Filter
Top Products
13
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
oPeraTing hinTs
1. Burn only dry, well-seasoned wood for maxi-
mum heat output. In some states it is illegal to
burn wet wood or anything other than clean,
dry wood products.
2. Your stove is designed to operate with the door
closed! Operate only with the door shut tightly
at all times except when loading wood.
3. DO NOT hit or move the baffle brick while load-
ing wood. Occasionally check the baffle. Make
sure the insulating blanket is always flush with
the front of the baffle brick. Loading oversized
logs may dislodge the baffle bricks.
4. CAUTION: THE DRAFT CONTROL MUST BE
FULLY OPEN BEFORE OPENING THE DOOR
TO AVOID POSSIBLE COMBUSTION FLASH!!
(Ignition of hot volatile gases as the door is
opened).
5. Feeding excessive amounts of fuel to the stove
should be avoided. It is important to supply
it with sufficient draft and fuel to maintain a
moderately hot fire. If, during overnight burns,
heavy creosote deposits develop inside your
stove and on the door, the draft is set too low
- review your burning habits!
oPTional BloWer insTallaTion
A blower, part # 71000, can be installed on the stove to
improve hot air distribution throughout the room.
To install the blower:
1. Remove all the contents from the blower box. In-
cluded with the blower should be a blower speed
control.
2. Remove the screw in the round knock-out plate
on the back of the stove. Bend the knock-out plate
back and forth until it can be removed.
3. Mount the blower as shown below. Make sure the
cord is at the bottom when mounted and that it
does not touch the stove anywhere. Remove the
four screws from the back of the stove. Use one of
the four screws with a washer on it and attach the
blower through one of the four mounting legs on
the blower housing. Check to make sure that the
fan blade does not touch the large hole in the rear
heatshield. (Spin it to check all directions). Finish
attaching the blower with the other three screws.
Tighten the screws moderately tight but do not over
tighten as you may strip the holes out.
4. Plug in the fan speed control into the nearest outlet,
then plug the blower cord into the speed control.
Do not route the fan power cord under the stove or
allow it to come in contact with any surface of the
stove. Read the section Starting and Maintaining a
Fire for proper fan operating instructions on page
15.
WARNING: In the event that you remove the blower for any
reason, make sure a cover plate available from Lennox
Hearth Products is reinstalled before using the heater.
Excessive rear wall temperatures will result if the stove
is burned without the cover plate.