Filter
Top Products
34
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Step 11. HOOD INSTALLATION
The hood is optional for these products. In "Shadow Box" installations, the hood may not be
desired. If the opening above the door is objectionable (as is the case in certain "Flush-Mounted"
installations) the hood may be used.
Position the hood in the opening and insert the three mounting tabs into the slots located on the
angled air plenum ramp above the opening above the door.
FINISHING REQUIREMENTS - Wall Details
Complete finished interior wall. To install the appliance facing flush with the finished wall, position
framework to accommodate the thickness of the finished wall (Figure 54).
See Page 5 for Cold Climate Insulation
and Page 8 for Clearances
Combustible
Finished Wall
Materials
This Area Must Remain
Clear of Combustible
Materials
Top of Appliance
1" Min
(25 mm)
Spacer
Clean Face Models
Top of Door Frame
Combustible
materials not
allowed below
this point on
the face of the
appliance.
Venturi
Air
Shutter
Rod
Valve
Lever Arm
RENRUBNIAM
GNITTESGNINEPORETTUHSYROTCAF
sledoM
saGlarutaN
)mm(sehcni
saGenaporP
)mm(sehcni
53VDLE8/1)2.3(8/3)5.9(
04VDLE)4.6(4/1)1.11(61/7
54VDLE)4.6(4/1)1.11(61/7
Figure 53
Figure 54