Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
8
Log Placement
WARNING: THE SIZE AND POSITION ON
THE LOG SET WAS ENGINEERED TO GIVE
YOUR APPLIANCE A SAFE, RELIABLE
AND ATTRACTIVE FLAME PATTERN.
ANY ATTEMPT TO USE A DIFFERENT
LOG SET IN THE STOVE WILL VOID
THE WARRANTY AND WILL RESULT IN
INCOMPLETE COMBUSTION, SOOTING,
AND POOR FLAME QUALITY.
WARNING: LOGS GET VERY HOT AND
WILL REMAIN HOT UP TO ONE HOUR
AFTER GAS SUPPLY IS TURNED OFF.
HANDLE ONLY WHEN LOGS ARE COOL.
TURN OFF ALL ELECTRICITY TO THE
APPLIANCE BEFORE YOU INSTALL
LOGS.
WARNING: THIS APPLIANCE IS NOT
MEANT TO BURN WOOD. ANY ATTEMPT
TO DO SO COULD CAUSE IRREPA-
RABLE DAMAGE TO YOUR APPLIANCE
AND PROVE HAZARDOUS TO YOUR
SAFETY.
WARNING: IF LOGS ARE NOT INSTALLED
ACCORDING TO THE DIRECTIONS
SHOWN HERE, FLAME IMPINGEMENT
AND IMPROPER COMBUSTION COULD
OCCUR AND RESULT IN SOOT AND/OR
EXCESSIVE PRODUCTION OF CARBON
MONOXIDE (CO), A COLORLESS, ODOR-
LESS, TOXIC GAS.
Figure 9
Ember
Strip
Rear Log Stoppers
Rear
Log
Figure 10
2. Place the largest log onto the rear log
stoppers (see Figure 9). Ensure that the
grooves on the bottom of the log aligns
onto the corresponding places on the rear
log stoppers. Push the log back so that it
is against the back of the rear log stoppers
(see Figure 10).
Left Front Log
Figure 11
Center
Log
Piece
Figure 12
4. Place the center log piece over the cor-
responding pins next to the front left log as
shown in fi gure 12.
3. Place the left front log onto the corre-
sponding burner pin and sub-fl oor left tab
as shown in Figure 11.
5. Install the right front log onto the cor-
responding burner pin and sub-fl oor right
tab as shown in fi gure 13.
Right Front Log
Figure 13
Figure 14
Left Top
Twig
6. Install the left top twig onto the correspond-
ing pin on the rear log and align it with the
indentation on the front left log as shown in
fi gure 14.
Center
Top Twig
Right
Front Twig
7. Install the center top twig onto the cor-
responding pin on the rear log and align it
with the indentation on front left log as shown
in fi gure 15.
8. Install the front right twig onto the cor-
responding pin on the right front log. Align
the twig with the indentation on the front right
log as shown in fi gure 16.
Figure 15
Figure 16
Carefully install this seven-piece log set into
the fi rebox as shown in these instructions.
All logs should fi t onto corresponding pins
and/or log stoppers. This will ensure a proper
fl ame and safe combustion.
1. Place the ember strip in front of the burner
as shown in Figure 9. It should be positioned
all the way back (toward the sub-fl oor front
fl ange).