Filter
Top Products
2
5. Install the facade onto the fireplace face per instructions in Figure 3.
6. See
Figure 4 for instructions on accessing the control compart-
ment.
To access the control compartment, pull the hinged door
forward and up as shown. To close, hinge the door closed
until magnets secure it in place.
Figure 4 - Opening the Control Compartment Panel
Figure 5 - Completed Installation
IMPORTANT NOTE (Gold and Nickel Finishes Only): The gold
and nickel finishes will require heat to harden and cure (after
approximately 3 fires, the finish will be completely cured). Prior
to burning this appliance the gold and nickel surfaces should be
cleaned thoroughly with a good window cleaning solution and a
soft cloth. Do not use any metal polishes or abrasives to clean
the surfaces. Any oils or fingerprints left on the finish during the
curing process may become permanent blemishes.
Magnets
Control Compartment
Control Compartment Panel
Facade
3. Using a 3/8” socket or nutdriver, install the upper filigree inset, lower
filigree inset, screen and screen retainer with provided washers and
nuts as shown in Figure 2. Note: you will have four extra washers
and nuts.
4. Reinstall heat shield aligning the top corners of the heat shield with
the etch marks in the back of the facade for proper placement. Do not
over tighten nuts.
Figure 2
Brushed Nickel
Facade Shown
Figure 3 - Install Facade
Tabs on Bracket
Assemblies (2
places each side)
Slots on Fireplace
(2 places each side)
Facade
Align the tabs on the
bracket assemblies all
the way into the slots
on fireplace, then push
facade down to ensure
engagement.
Printed in U.S.A. © 2008 Lennox Hearth Products
P/N 750,231M REV. NC 06/2008
Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products.
Consult your local distributor for fireplace / insert code information.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Lennox Hearth Products
1110 West Taft Avenue • Orange, CA 92865
Note: There are two mount-
ing positions on the facade
hanging brackets to better
accommodate a range of
facing thicknesses. Adjust
to the notch on the hanging
bracket that works best for
your installation.
Heat Shield
Upper Filigree
Lower Filigree
Screen
Screen Retainer
Etch
Marks