Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE
2
Figure 5
Door Installation:
Step 1. Starting with the lower end of either the right or left hand door
hold the door at a slight angle to the door frame outer edge with the
top tilted toward the center.
Swing the lower corner of the door over the hole in the lower frame
and engage the lower pivot pin into the hole on the lower frame of the
firebox opening (
Figures 5 and 6
).
Pivot
Point
Lower
Frame
Pivot Pin
Roller Pin
Lock
Frame Assembly:
Assemble the four piece door frame with the eight (8) screws provided
as shown in
Figure 3
. Two spring clips attach inside the upper track as
illustrated.
Figure 3
Figure 4
After assembly, the frame inserts under the hood as shown in
Figure 4
and drops down inside the opening without fasteners.
Assembled
Door Frame
Figure 2
Hood Installation:
Begin the assembly by installing the hood (packaged separately). Be
certain to remove any protective plastic coatings for the stainless steel
parts before installing those components.
Step 1. Turn off the fireplace and allow it to cool before proceeding.
Step 2. Place the hood lip under the face top opening, as shown in
Figure 2
- Step 1. Attach the hood with two (2) screws, one each side,
as shown in
Figure 2 -
Step 2.
Spring Clip
Screws (8)
Place The Hood
Lip Up And
Under The Face
Top Opening
Hood Lip
Attaching Screw
(Seen From Below)
Step-1
Step-2
Face Top