Storageflex RMC-LC20LP(T) Electric Heater User Manual


 
15
Accessories continued
CAUTION: Damaged power cord can cause a fire or electric
shock.
Prior to installing the blower, check for blower for any shipping
dama
ge.
If blo
wer is damaged, promptly inform dealer where
you bought the blo
wer
.
INSTALLATION: Plug the blower power cord into a 110-120V
properly grounded type outlet (three prong receptacle) protected
by a 15 amp time delay or Circuit Sa
ver fuse for circuit breaker
.
WARNING: Do not let your fingers touch the prongs of plug
when installing or removing the plug from the power outlet.
OPERATION:
Manually Oper
ated:
Use the ON/OFF rocker s
witch to manually
s
witch the blo
wer ON or OFF as desired.
Manually & Thermostatically Controlled: Use the
MAN/OFF/AUTO rocker switch to MAN for manual ON or AUTO
for thermosta
tically controlled operation as desired. Thermostat
turns the blo
wer ON when the tempera
ture near the discharge
area reaches 105F and turns it OFF when the temperature at the
aforementioned location goes down to 86F.
MAINTENANCE:
WARNING: For your safety, turn switch “OFF” and remove plug
from po
wer source outlet before c
leaning and maintaining
blower. If power cord is worn, cut, or damaged in any way,
have it replaced immediately.
CARE OF BLOWER
In normal use, blower may accumulate excessive lint or dust,
so the blower should be vacuumed or brushed and checked
for proper operation at least once each year by a qualified
service personnel. Excessive accumulation of lint and dust can
cause the blower motor to overheat frequently and burn out.
CFM Home Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and
products at any time, without notice.
WARNING: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this
heater may result in property damage or personal injury.