Filter
Top Products
8
FC-42 - Connecting the FC-42
5 Connecting the FC-42
Always switch off the power to each device before connecting it to your
FC-42. After connecting your FC-42, connect its power and then switch
on the power to each device.
To connect the FC-42, as illustrated in the example in Figure 3, do the following:
1. Connect a component video source (for example, an HDTV Satellite receiver
source) to the Y, PB, PR INPUT BNC connectors.
2. Connect the OUTPUTS:
Connect the SDI BNC connector to an HD-SDI acceptor (for example,
a non-linear editor)
Connect the SDI BNC connector to an HD-SDI acceptor (for example,
an HD-SDI display)
Connect the RGB/HV 15-pin HD computer graphics video connector to
an RGBHV acceptor (for example, a projector)
3. Connect a PC or other controller, if required (see Section 5.1).
4. Connect the power cord (not shown in Figure 3).
i