Filter
Top Products
8
6810HDxl - Operating the 6810HDxl
5 Operating the 6810HDxl
To operate the 6810HDxl as an embedder:
1. Connect the audio sources to the AUDIO IN TO EMBEDDER connectors.
2. Choose the target group by pressing the EMBEDDER GROUP SELECT
button.
The display cycles through groups 1, 2, 3, 4, and –
The “–“ indicates that no group is chosen and the given channels are not
embedded.
If no audio is connected to the AES inputs, the display shows “–“.
3. The audio channels are embedded from the audio sources into the selected
groups of the SDI data stream.
If audio was already embedded in the groups of the SDI stream, it is replaced by the
audio embedded by the 6810HDxl.
To operate the 6810HDxl as a de-embedder:
1. Connect the AUDIO OUT TO DE-EMBEDDER connectors to the audio
acceptors.
2. Choose the source group by pressing the DE-EMBEDDER GROUP
SELECT button.
The display cycles through groups 1, 2, 3, 4, and –.
The “–“ indicates that no group is chosen and the given channels are muted.
You can scroll only the groups where audio is detected (as indicated by the Audio
Group Detect LEDs)
3. The audio channels are de-embedded from the selected groups of the SDI
data stream to the audio acceptors.
Note: You cannot de-embed the same group for two channels at the same time.