- 5 -
Technical data
Mains voltage: 230-240 V
~
50Hz
Power cable length: 1.8 m with switch
Power consumption : 50 W
Protection class: II /
Bulb type: max. 50 W / GU 10
Lamp base: 16 cm in diameter
Items supplied
1 Desk lamp, pre-assembled
1 Counterweight
1 Hexagon spanner
1 Suction disc for bulb exchanges
1 Operating manual
• Check to ensure that the appliance is undamaged,
all component parts are present and that pack-
aging remnants are removed from it.
Appliance description
q
Counterweight
w
Power cable
e
Hexagon spanner
r
Suction disc
t
Switch
y
Lever for lamp adjustment
u
Lever for swivel-arm locking
Assembly
For reasons of transportation the lamp is supplied
pre/assembled.First put the components together
completely before operating the lamp:
• Turn the counterweight
q
onto the rear of the
swivel-arm.
• Carefully pull the power cable
w
so far out of
the lamp base until the swivel arm is flush in the
lamp base.
• Lock the swivel arm into the lamp base with the
hexagon spanner
e
.
• Place the suction disc
r
onto the front of the
bulb and press it firmly. Guide the bulb into the
bulb holder and secure it by turning it through
a quarter-turn in a clockwise direction.
Attention!
Do not forget to remove the suction disc! Do
NOT operate the lamp with the suction disc
fitted – it would be melted immediately by the
heat.
Utilisation
• Place the lamp at a suitable location, as detailed
in the Safety Instructions.
• Insert the power cable into the wall socket. You
can now switch the lamp on and off at the
switch
t
.
• Always adjust the position of the lamp with the
lever
y
, not with the lamp housing. This can
get very hot when in use.
• You can adjust the swivel-arm in that you first
loosen the locking device
u
. Move the swivel-
arm to the desired position and then retighten
the locking device.
IB_KH4164_KOE6029_UK_3.qxd 29.10.2007 8:48 Uhr Seite 5
