5
Safety information
ƽ Danger of electrocution!
• Connect the appliance only to a 50 Hz grounded
power socket with mains voltage of 230 V~ and that
has been installed according to instructions.
• Do not bend or squeeze the power cord.
•To disconnect, always pull out the plug at the power
socket, do not pull on the power cord.
• Never touch the chimney, power cord and power plug
with wet hands.
• Do not use extension cables.
• Do not wind the power cord around the casing of the
chimney.
• Unplug your chimney immediately after use. The
power plug is completely free of power supply only
when you pull it out of the power socket.
• Do not immerse the chimney in liquids under any
circumstances and do not allow any liquids to enter
the device casing of the chimney. Do not expose the
appliance to humidity and do not use it outdoors.
There exists the danger of electrocution. However, if
liquid does enter the device casing, pull out the plug
of the appliance from the power socket and have it
repaired by a qualified technician.
• Never us the chimney in proximity of water or in
damp cellar areas. The proximity to water presents a
danger, even if the chimney is switched off.
• In case of a breakdown and before cleaning the
chimney, pull out the power plug from power socket.
• If the power cord is damaged, have the chimney
repaired by a qualified technician, before you use it
again.
• Do not operate the chimney, if it has fallen down or is
damaged. Have the appliance checked or repaired by
qualified technicians.
• Do not open or repair the device casing of the chim-
ney. In such cases, safety shall not be guaranteed
and the warranty shall expire. Allow only authorised
technicians to repair the defects in the chimney.
ƽ Fire hazard!
• Never place the chimney close to inflammable materi-
als, liquids or gases. Leave at least a one meter
space on all sides and on the top. Never place the
chimney directly under a wall socket.
• Do not cover the appliance when in operation. Clean
it at regular intervals.
• Never leave the chimney unsupervised when in
operation.
• Always place the chimney on an even base.
Otherwise, the chimney could tip over and lead to a
fire.
• Never place the chimney close to heat sources, and
protect the power cord from damages. Therefore, do
not keep the power cord lying in front of the chimney.
• Do not use the chimney with a time switch or a simi-
lar appliance. In case of auto-start, there exists a fire
hazard if the chimney is covered or has been set up
incorrectly.
ƽ Risk of injury or burning
• Never insert objects or body parts such as fingers
inside the chimney through the iron rods.
• Never allow children to use the chimney without the
supervision of an adult. Explain to children the dan-
gers of the appliance.
• The chimney heats up when in operation. Therefore,
never carry it when hot and do so only by the handle
provided for this purpose
• Lay the power cord such that no one treads or trips
over it.
Intended Use
The chimney is used for decorating ad heating living
rooms.
This chimney is exclusively meant for household use
and may be used only for this purpose. Observance of
all the information in these operating instructions, espe-
cially the safety instructions is also from this point of
view.
This chimney is not intended for commercial or industri-
al use.
Description of the appliance
➀ Function switch
➁ Thermostat
➂ Flame regulator
➃ Screws of the glass top
➄ Glowing embers
Technical Data
Rated voltage: ..........................................230 V / ~50 Hz
Power rating: ..........................................Max. 1850 Watt
Light bulb : ..................2 candle bulbs, E-14, max. 25 W
Before the First Use
Before starting up the appliance, make certain that ...
➩ the appliance or the accessories are in perfect condi-
tion,
➩ all the packing material has been removed.
IB_KH1117_UK.qxd 16.09.2004 8:27 Uhr Seite 5