Filter
Top Products
2. Install the Lavatory
Cut out the opening by carefully following the pencil line traced
from the template.
CAUTION: Risk of personal injury or product damage. Handle
with care. Vitreous china can break or chip if the product is
handled carelessly.
Temporarily set the lavatory into the countertop cutout to check
for fit.
Remove the lavatory from the countertop cutout.
Install the wall-mount faucet according to the manufacturer’s
instructions.
K-2271
NOTE: Do not substitute another sealant for the one provided. The
supplied sealant is required to permanently bond the lavatory to the
countertop.
Apply two 1/8″ (3mm) beads of sealant around the countertop
cut-out hole. Apply the first bead of sealant approximately 1/4″
(6mm) away from the cut-out hole edge. Apply the second bead
about 1-3/8″ (3.5cm) from the first bead. (see illustration)
Set the lavatory into the countertop cutout. Use care to avoid
smearing the sealant beads.
1/8" (3mm) Thick
Bead of Sealant
1/8" (3mm) Thick
Bead of Sealant
3/8" (1cm)
(TYP.)
3" (7.6cm)
Rim of
Lavatory
Cut-out
Hole
Cut-out
Hole
3" (7.6cm)
1-3/8"
(3.5cm)
1/4"
(6mm)
K-2271 K-2273
1018899-2-A 4 Kohler Co.