Filter
Top Products
5. Install the Faceplate and Handle
CAUTION: Risk of product damage to the K-306-KS valve
assembly. When using this valve in a fiberglass or acrylic
installation, use the Thin Wall Installation Kit (88526).
Remove and discard the plaster guard and/or dome, if installed.
Rotate the valve stem fully counterclockwise to the ″Off″ position.
Install the faceplate onto the valve. Secure with two screws. Do
not overtighten.
Slide the sleeve over the valve stem with the slot down and
facing outward.
Scroll Handle
Install the handle to the base.
Secure with a screw.
Align the handle assembly and press it onto the valve stem.
Secure the handle in place with the setscrew. Tighten the setscrew
to one quarter-turn past hand-tight.
Traditional Handle
Assemble the handle and bonnet.
Install the washer and O-ring onto the base.
Fit the handle assembly to the base.
Secure with a screw.
Faceplate
Sleeve
Slot
Valve Stem
Screw
Discard plaster
guard with dome.
Faceplate
Washer
O-Ring
Bonnet
Screw
Base
Setscrew
Traditional
Handle
Scroll
Handle
Kohler Co. 9 1025255-2-C