Filter
Top Products
1. Install the Spout and Handspray
IMPORTANT! The maximum sink or counter thickness is 1″
(2.5 cm) for this installation.
Apply a bead of plumbers putty or other sealant to the underside
of the spout base according to the manufacturer’s instructions.
Thread the nut and washer to the bottom of the shank until the
nut touches the top of the shank tee.
Insert the shank from the bottom of the sink.
Thread the shank into the bottom of the spout between 16 and 19
turns so it is hand tight.
Loosen the shank 1/8 of a turn.
IMPORTANT! Do not loosen the shank more than 1/2 turn. The
spout may not seal, resulting in a leak.
Tighten the nut and washer to secure the shank to the sink.
Slide the spray holder through the mounting hole from above.
Securely hand tighten the nut to the spray holder from under the
sink.
Insert the handspray hose through the spray holder.
Attach the handspray hose to the shank tee.
Wrench tighten the nut.
Spout
Base
Handspray
Spray Holder
Mounting Hole
Spray Holder Nut
Shank
Shank Tee
Handspray Hose
Shank Nut
Washer
Sink
Spout
Apply plumbers putty.
Kohler Co. 3 1004636-2-D