Filter
Top Products
5
1063864-AN2-E 17/02/12
Finish the Installation
1. With the ribs of the sprayhead facing up,
attach the sprayhead to the waterway.
2. Using a 3/16” hexagonal key, secure
the sprayhead to the waterway with the
2 securing screws (supplied). Do not
overtighten.
3. Check the sprayhead for upward and
downward movement and that it sits
squarely within the housing.
4. Place the nozzle membrane over the
sprayhead
Note! For optimum performance make
sure that the membrane is applied
evenly.
5. Tilt the sprayhead downward so that
the ribs on top of the sprayhead are
exposed.
6. Insert the grooves of the sprayface over
the ribs of the sprayhead.
7. Press the sprayface down to cover the
sprayhead, as illustrated.
8. Tilt the sprayhead upwards to expose
the setscrew holes on the bottom of the
sprayhead.
Important! The setscrews must be flush
with the edge of the sprayface frame. If
the setscrews protrude outside of the
sprayface frame product damage will
occur.
9. Using a 7/64” hexagonal key, turn the
setscrews anti-clockwise
until they are
flush with the edge of the sprayface
frame.
Hex Screws
Waterway
Sprayhead
Groove
Ribs
Nozzle
Membrane
Finished Wall
Ribs
Sprayface
Setscrews
Attach the Sprayhead
Attach the Sprayface