Filter
Top Products
1011420-2-B
3
Kohler Co.
Spacer Block
End Cap
Dome Cap Cover
#10 x 1-1/4” Screw
Recommended Holes
Make sure beveled end is
facing toward the front
1. Install the End Caps
- Locate the spacer blocks taped to end caps.
- Using a piece of masking tape, tape the spacer blocks in location on the outside of the cabinets. Make sure the
pilot holes line up with the recommended holes in the mirror cabinet.
- Install each end cap so the beveled edge is towards the mirror and the front of the cabinet. Align the end cap so
that it is centered to mirror height. Hold or clamp carefully (protect the surface if clamping) until attachment
screws are in place.
- Drive the #10 x 1Ć1/4" screws provided through the inside location holes, through spacer block holes and into the
predrilled end cap holes.
- Place dome cap covers over the screw heads.