Kidde 1SF23/9HI Smoke Alarm User Manual


 
9. Troubleshooting
Always turn off the mains supply to AC alarms before checking connections etc..
10. Useful Hints
Smoke/heat alarms can only operate correctly if smoke particles/heat reach the
unit. Correct selection/siting and installation are covered in the installers manual,
who fitted your alarm/s.
UK Building Regulations require new homes to have 1 hard wired smoke alarm
per floor and to be interlinked. During 2000 they will additionally require an
interlinked heat alarm to be fitted in most kitchens too. i.e. 3 alarms per property.
With the exception of garages/kitchens/bathrooms it is recommended that
smoke alarms are fitted in every room and outside all sleeping areas too.
A professional electrician should be employed for all mains powered (hard
wired) alarms.
If you are redecorating your home, paint fumes can contaminate the alarm
temporarily cover the unit with a plastic bag (during this time the alarm will not
function). Never paint the alarm itself.
Only remove the bag when the paint is thoroughly dry.
If you extend your property, review your alarm requirements.
Smoke/heat alarms should be replaced every 10 years or sooner.
These products are designed for domestically scaled premises.
9
Symptom
1. Green L.E.D. not lit
2. Frequent nuisance
alarms
3. Alarm chirps every 40
seconds
4. Alarm does not sound
when test button
pressed and held.
5. Interconnected alarms
do not sound when
test button is pressed
and held.
Possible cause/solutions
a. Loss of mains power check at Consumer Unit
for Blown Fuse or tripped Circuit Breaker.
b. Check cables at back of alarm, are correctly
seated / wired in and the alarm is pushed fully
home (see Battery Changing section).
See sections 4d and 7.
See section 5 (if the hush button has been pressed
the unit will chirp for 7 minutes to indicate it is in
hush mode).
See parts 1a and 1b above.
See part 1b above consult a qualified electrician
or your Landlord to remedy as soon as possible.