Filter
Top Products
on the battery carrier. Completely press the battery carrier down into the alarm and release, the battery
carrier will lock into the closed position.
A missing or improperly installed battery will prevent the battery carrier from closing and result in
improper alarm operation.
This smoke alarm uses a 9V carbon zinc battery (alkaline and lithium batteries may also be used). A
fresh battery should last for one year under normal operating conditions.
This alarm has a low battery monitor circuit which will cause the alarm to “chirp” approximately every
30-40 seconds for a minimum of seven (7) days when the battery gets low. Replace the battery when
this condition occurs.
USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE ALARM REPLACEMENT.
Carbon-zinc type EVEREADY 216 OR 1222; GOLD PEAK 1604P OR 1604S
Alkaline type ENERGIZER 522; DURACELL MN1604 OR MX1604; GOLD PEAK 1604A
PANASONIC 6AM6, 6AM-6, 6AM-6PI, 6AM6X, AND 6LR61 (GA)
Lithium type ULTRALIFE U9VL-J
NOTE: WEEKLY TESTING IS REQUIRED!
NOTE: IF AFTER BATTERY REPLACEMENT THE ALARM CONTINUES TO CHIRP, PUSH THE TEST
BUTTON. THE HUSH® FEATURE MAY HAVE BEEN ACTIVATED ACCIDENTLY WHILE CHANGING
THE BATTERY AND PUSHING THE TEST BUTTON WILL END THE HUSH® CYCLE.
WARNING! BE SURE TO FOLLOW BATTERY INSTALLATION INSTRUCTIONS PRINTED ON THE
BACK OF THE ALARM AND USE ONLY THE BATTERIES SPECIFIED. USE OF DIFFERENT BATTER-
IES MAY HAVE A DETRIMENTAL EFFECT ON THE SMOKE ALARM.
CLEANING YOUR ALARM.
YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR
To clean your alarm, remove it from the mounting bracket as outlined in the beginning of this section. You
can clean the interior of your alarm (sensing chamber) by using compressed air or a vacuum cleaner hose
and blowing or vacuuming through the openings around the perimeter of the alarm. The outside of the
alarm can be wiped with a damp cloth. After cleaning, reinstall your alarm, verify the green LED is on and
test your alarm by using the test button. If cleaning does not restore the alarm to normal operation the
alarm should be replaced.
.
.
s,
,
e
s
t.
"
r
d
PRESS
OPEN
INSERT
820-0921 _0976.qxd 02/03/05 7:02 PM Page 7