Filter
Top Products
KETTLER® International Inc. • 1355 London Bridge Road • Virginia Beach, VA 23453
www.kettlerusa.com • info@kettlerusa.com
Care & Maintenance
Ocean Comfort products are constructed from HDPE (High Density Polyethelene), primarily a
recycled material. UV inhibitors are also added to resist fading. Simply maintain your furniture by
cleaning with soap and warm water to ensure its long lasting beauty. A soft bristle brush can be used
on any tough to clean stains. Stainless steel hardware is used in the assembly of these products and
should be rinsed regularly with fresh water if being used in a coastal environment.
KETTLER Limited Warranty
Ocean Comfort products are guaranteed for a period of 20 years (for residential use) and 5 years (for
commercial use), starting from original purchase date. This warranty covers defects in materials and/or
workmanship and does not apply to the hardware.
Warranty not applicable to any products deemed as misused, abused or damaged due to an uncontrollable act
of nature.
*For Parts and Service, please contact us directly at 866-804-0440 or email parts@kettlerusa.com
Made in the U.S.A.
Assembly Instructions continued
5.
a. Bolt the left and right side braces onto the front legs
by aligning the predrilled holes and inserting a 1/4 - 20
x 2 1/2” Bolt. Clean any plastic residue from the bolt
then slide a washer on. Screw on the locknut and then
tighten it with the wrench and phillips screwdriver.
b. Then align the side braces to the holes on the
back legs, place the short brace across between them
aligning with the predrilled holes. Insert the 1/4 - 20
x 2 1/2” thru the leg, in thru the side brace and into
the short brace. Tighten with the phillips screwdriver.
Repeat on the other front leg.
3b. Aligning holes
on the side brace with
the back leg, place
the short brace in
then insert bolt.
3a. Aligning holes on the
front leg and the side brace
then insert the bolt, slide on
a washer, screw on a locknut
and tighten.
3a.
3a.
3b.
3b.
Short brace goes in between the side
braces on the back of the stool.
6.
Place the footrest on the side braces align the front
predrilled holes and insert the 1/4 - 20 x 2” Bolts through the
footrest and into the end hole of the brace then tighten it with the
phillips screwdriver.
Place the footrest on the side
braces align the front predrilled
holes and insert the bolts.
6.
5.