Filter
Top Products
Copyright © Kettler USA 309.01
Place arm rest on top of chair legs, align
front predrilled holes, insert bolt.
2533 ADIRONDACK BAR STOOL
Contents:
(1) Seat, (1) Back
(2) Arm Rests
(2) Front Chair legs
(2) Back Chair legs
(1) Footrest
(2) Side Braces
Tools Required:
7/16” Wrench
(1) Short Cross Brace
(4) Cross Braces
(22) 1/4 - 20 x 2” Bolts
(6) 1/4 - 20 x 2 1/2” Bolts
(12) Washers
(12) Locknuts
1.
a. Align predrilled then
insert bolts to attach
front legs.
b. Align predrilled
holes then insert bolts
to attach back legs.
2.
Locknut Washer 1/4-20 x 2” Bolt
#3 Phillips Head Screwdriver
Properly Seated
Washer and Nut.
Assembly Instructions
1.
a. With the wing on the post facing front,
align the predrilled holes on front leg to the seat
and insert the 1/4 - 20 x 2” Bolts through the leg
in thru the seat. Clean any plastic residue from the
bolt then slide a washer on. Screw on the locknut
and then tighten it with the wrench and phillips
screwdriver. Repeat on the other front leg.
b. Align the predrilled holes on the back leg to
the seat and insert the 1/4 - 20 x 2” Bolts through
the leg in thru the seat. Clean any plastic residue
from the bolt then slide a washer on. Screw on the
locknut and then tighten it with the wrench and
phillips screwdriver. Repeat on the other back leg.
2.
Place arm rest on top of chair legs align the
front predrilled holes and insert the 1/4 - 20 x 2”
Bolts through the leg and in thru the arm. Clean
off any plastic residue then slide a washer on the
end of bolt. Screw on the locknut and then tighten
it with the wrench and phillips screwdriver.
3.
a. Attach the back of the chair to the seat
by aligning holes and inserting a 1/4 - 20 x 2”
Bolt then tighten with a phillips screwdriver.
b. Attach the back of the chair to the arm by
aligning holes and inserting a 1/4 - 20 x 2 1/2”
Bolt thru the arm, leg and into the chair back, then
tighten with a phillips screwdriver.
Repeat on both sides.
4.
Attach the cross braces of the chair to the
legs by aligning holes and inserting a 1/4 - 20 x
2” Bolt through the leg into the cross brace and
tighten with a phillips screwdriver.
Repeat on other leg.
Do Front and Back cross braces.
Slide washer then
locknut onto end of
bolt then tighten.
Attach the braces to
the legs by aligning
holes and inserting
a 2” bolt.
4.
Attach the back of the
chair by aligning holes
on the arm and the seat
to insert bolt.
3.
3b.
3a.