Kenmore 85244 Air Cleaner User Manual


 
HOW iT WORKS
This Air Cleaner is equipped with a HEPA (High Efficiency Particulate
Arrestor) filter. Room air is drawn into the Air Cleaner through the Air
intake Grille and passes through the HEPA filter. The filtered air is
released from the top of the unit and is dispersed upwards into the room.
The Air Cleaner has three operating speeds: HI, MED and LO.
The indicator light is "ON" when the Air Cleaner is operating.
Your Air Cleaner has an ionizer with a red light indicating when
it is turned "ON".
Use of ionizer boosts cleaning efficiency and revitalizes stale air.
SET UP
Your Air Cleaner was thoroughly inspected and tested at the
factory prior to packaging. Visually inspect it upon removal
from its box. Remove and discard any packaging material.
Return the unit if it shows any signs of damage or mishandling.
Adjust the filter change wheel to properly indicate when the
next filter change is necessary.
ELECTRICAL HOOKUP
Plug the Air Cleaner into a polarized 120-Volt AC wall outlet.
iZ_WARNiNG:Toavoidtheriskoffireore,ectricshockhazard, thej
Air Cleaner should ONLYbe plugged into a polarized 120-Volt AC outlet,
OPERATION
Z_CAUTION! NEVER operate the Air Cleaner without the HEPA filter ]
properly installed, Permanent motor damage cou|d result.
]
Each time you start the Air Cleaner, it is a good idea to run it
at Hi speed for a few seconds for fast, initial cleaning. Then
set to MED or LO as desired.
4