Filter
Top Products
C. PROGRAM THE TIMER
f
signal light adjust_ salt level\ adjust display
_=\
R_CHARGE _ Customer Assistance
TONIGHT 1-800-426-9345
RECHARG_ ww_KeftmoreWate_co_
"=" ©
LOW
SALT
!
ON/OFF-HOLD button
{Recharge Tonight-Now)
UP button SELECT button
I /
@
DOWN button
When the transformer is plugged in, a model code,
and a test number (example: k20) show in the face
plate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
UltraSoft 250
5'- _C_ _2_ IC,UU'_ 17'7A'
pREREIqT _ME
UltraSoft 275
I 717f7 'v'
S,-33 h20 c,w
PRESENT TIME
a change in the face plate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, while setting the hardness
(step 2), the beeper sounds repeatedly when the dis-
play reaches I using the DOWN button, or the high-
est hardness setting using the UP button.
[]SET PRESENT TIME OF DAY
Notes:
If SR - - shows in the display, press the UP_ or-
DOWN[_ button until SR29 shows for the Ultra-
Soft 250 or SR33 shows for the UltraSoft 275. Then,
press the SELECT button to set, and change to the
flashing PRESENT TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again, if other than these
codes show, see page 5-3 to reset.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for timer set-up. One beep signals
If the words PRESENT TIME do not show in the dis-
play, press the SELECTbutton (FIG. 2) until they do,
or see the previous notes.
• Press the UP / DOWN buttons to set the present
time. Press UP to move the display ahead; press
DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
4'58"
PRESEP+IT_ME
_71-"_,,t
I 1'_70 1
PRESENT'ME )
Each press of the UP /DOWN buttons changes
the time by 1 minute. Holding the buttons in
changes the time 32 minutes each second.
1-3
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line