Filter
Top Products
I_l INSTALL THE AIR CONDITIONER IN THE
WINDOW
• Carefully liftthe air conditioner and slide it intothe
open window. Make sure the bottom guide of the air
conditioner drops into the notches of the L brackets.
• When the air conditioner drops into the L brackets,
the air conditioner will be centered in window opening
as shown in FIG. 7.
• While steadying the air conditioner, carefully bring the
window sash down behind the upper guide of the air
conditioner, as shown in FIG. 8.
CENTER LINE FIG. 7
WINDOW FRAME
UPPER GUIDE _SEAL 1
-t-
ABOUTq4"
FIG. 8
_ SECURE THE GUIDE PANELS
Extend the guide panels (ITEM F) to fill the
window opening using 4 screws (ITEM B) to
secure them, as shown in FIG. 9.
I_l INSTALL THE SASH SEAL AND SASH LOCK
• Cut the sash seal (ITEM E) to the window width.
Stuff the sash seal between the glass and the
window to prevent air and insects from getting into
the room, as shown in FIG. 9.
• Fasten the remaining L bracket on either side of
the window using screw (ITEM A). See FIG. 9
inset. Installing this bracket prevents window from
being raised which may result in unit falling.
I_IIF AIR CONDITIONER IS BLOCKED BY
STORM WINDOW FRAME
• If storm window presents interference, fasten a 2"
wide wood stripto the inner windowsill across the full
width of the sill. The wood stripshould be thick
enough to raise the height of the window sill so that
the unit can be installed withoutinterference from the
the storm window frame. See FIG. 10.
Top of wood stripshould be approximately 3/4"
higher than the storm windowframe to help
condensation to drain propedy to the outside.
• Install a second wood strip(approximately 6" long by
1112" wide and same thickness as first strip) in the
center of the outer sill flush against the back of the
inner sill. Screw the L brackets into this strip.
This will raise the L bracket as shown in FIG. 10.
WOOD STRIP MOUNTED 1"MAX.
ON TOP OF INNER SILL "-I_1 _ 3/4" _,
_ STORM
-_1 WINDOW
INNER FRAME
o IIIIIOLL
FIG. 10
REMOVAL FROM WINDOW
Turn the air conditioner off, and disconnect the
power cord. Remove the L bracket and the screws
installed through the top and bottom of the guide
panels, and save for reinstallation later. Close the
guide panels. Keeping a firm gdp on the air
conditioner, raise the sash, and carefully tilt the air
conditioner backward, draining any condensate
water. Lift the air conditioner from the window and
remove the sash seal from between the windows.
/
L BRACKET
FIG. 9
• Air conditioners covered inthis manual pose
an excessive weight hazard. Two or more
people are needed to move and install the unit.
To prevent injury or strain, use proper lifting
and carrying techniques when moving unit.
• When handling the air conditioner, be careful
to avoid cuts from sharp metal fins on front and
rear coils,
• Make sure air conditioner does not fall during
removal.
-7-