Filter
Top Products
When the bucket is full, or when l_e bucket is not in the proper position, the Bucket Fult light turns on
and the u_it automaticaty shuts ofi_
A_so, when bucket is out of position, the unit wtl beep 3 times.
The bucket must be replaced in the proper posilon for the dehumidifier to work, The fight will
be on and the dehumidifier wi|l net run if the bucket is not in the proper position,
The water" bucket can be emptied in one of three ways:
Empty the bucket manualy.
When the bucket is full,
remove and empty it into a
Iarge sink or tub. Whe_
finished, replace it properly.
NOTE: To replace the bucket
property, make sure the
slots on the back of bucket
are position_ correcty,
Place the dehumidifier
directly over drain.
The bucket has a threaded
hose connection which can be
left open. Drill a U4" (6.4ram)
to !/2"(13mm) hole in the
center of the hose connection.
Once opened, the hose
connection wll continualy
drain water from the bucket.
Attach a garden hose to the
threaded bucket drain hose
connection to carry water to
the drain, (HANDTIGHTENONLY}
When being attached to the
bucket drain hose connection,
be sure the hose doesn't kink
or bend. It should lie flat from
the dehumidifiet" to the drain.