Filter
Top Products
(7) (9) (lp) (1.1) (12) (1,3)
(4) (5) (2)
POWER ONtOFF (1)
Once the unit is plugged in, the POWER INDI-
CATOR (t0) will light up. Pressing the Power
button once will turn the unit ON and illuminate
the digital display (9). The display will show the
humidity level of the room in 5% increments
down to 25%. Pressing the Power button again
will turn the display OFF and the unit will cease
operating.
HUMIDITY LEVEL (2/3)
The humidity level can be set in 5% increments
in a range from 35% to 80%. The humidity
setting is shown in the digital display. When the
humidity level of the room reaches the set
level, the unit will stop dehumidifying.
To set the unit to continuous operation, press
the down arrow button until the display shows
35%. Press again and the display will show
CO. The Continuous indicator (13) will light up
on the control panel. To leave continuous op-
eration, press the up arrow button.
To check the current humidity setting, press the
up or down arrow button. The display will show
and set 5% above or below the current setting.
FANSPEED (5)
PressFanSpeed to togglebetweenLow,Med,
and High fanspeeds. Speed wiiJbeshownin
FANSPEED INDICATOR (8)
BUCKET FULL INDICATOR (11)
When the collection bucket isfull, the BUCKET
FULL indicator (11) will light up and you will
hear an audible alarm. The audible alarm will
last up to ten seconds The dehumidifier will not
run until the bucket is removed, emptied and
replaced.
(3) (1) (6)
DELAY START (4)
Unit canbe programmedtoturnonat a desired
delay time bypressing theTimer (4) key.
Whenthe unit ispoweredOFF, pressthetimer
keyoncefor 2-hourdelay start.The 2 Hrs (7)
timerindicatorwilllightupwhen the timerkey
ispressed.Pressthe timerkey oncemorefor a
4-hourdelay start.The 4Hrs (7)timerindicator
willnowlightup. Pressthetimerkey a third
timeto clearthetimersetting.Notimer indica-
tors willlightupwhen thetimersettingis
cleared.
AUTO SHUT-OFF (4)
Unit can be programmed to turn off at a desired
time by pressing the Timer (4) key. When the
unit is powered ON, press the timer key once
for 2-hour automatic shut-off. The 2 Hrs (7)
timer indicator willlight up when the timer key
is pressed. Press the timer key once more for a
4-hour automatic shut-off. The 4 Hrs (7) timer
indicator will now light up. Press the timer key a
third time to clear the timer setting. No timer
indicators will light up when the timer setting is
cleared.
FILTER RESET (12)
The FILTER RESET indicator (12) will light up
when the filter needs cleaning, Remove the
filter and clean accordingly. Replace the filter
when finished and press and hold the FILTER
(6) key upto 5 seconds to reset the filter indi-
cator.