Filter
Top Products
Z_WARNING
Electrical Shock and Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit. Failure
to do so could result in electrical
shock or personal injury from vacuum
cleaner suddenly starting.
TO REMOVE BELT
Nozzle
uard
t t t
Lay cleaner flat and flip cleaner to
expose nozzle base. Base should lay
flat and face up. Toremove nozzle
guard, remove 6 screws.
Rotate/pivot the nozzle guard and pull
off.
Lift and remove brushroll. Dispose of
old belt.
12
TO REPLACE BELT OR
BRUSHROLL
Motor
Shaft
Slide belt onto motor shaft.
Place new belt in area of brushroll
without bristles.
With new belt in place, pull and slide
brushroll into nozzle making sure that
the brushroll end caps are in the correct
orientation. Rotate brushroll manually to
make sure belt is properly aligned.
Reposition brush cover and 6 screws.
Tighten screws securely.