Kenmore 385.15516 Sewing Machine User Manual


 
Cleaning the Shuttle Race
This area must be kept free of dust, lint and
occasional tangled thread. Clean the shuttle race area
about every three months.
Cleaning the shuttle area
(_ Bobbin case
_) Levers
_) Shuttle race cover
(_ Shuttle
@ Shuttle race
_) Center pin on the shuttle
1. Raise the needle bar to its highest point and remove the
bobbin case _1_.
2. Push shuttle race levers _ aside. Lift shuttle race cover
(_ and take shuttle _ out.
3. Clean the shuttle race @ with a lint brush.
4. Put a drop of oil on the center pin of the shuttle (_ and
shuttle race @. Do not over oil.
S
Replacing shuttle assembly
(_ Levers
_) Shuttle race cover
(_ Shuttle
@ Shuttle race
_) Center pin on the shuttle
(_ Shuttle driver
(_ Pointed hook
(_ (Oil here)
1. Turn handwheel so that shuttle driver (_ is forming half
moon on the left side of the machine.
2. Hold shuttle(_ by center pin (_ and position shuttle so
as to form a half moon on the right side. The pointed
hook wilt be on the bottom.
3. Place shuttle race cover _) into place over shuttle
assembly.
4. Snap the levers _ back into the original position.
s
@-
®
7O