Filter
Top Products
Service and Adjustment (cont'd)
Element Cleaning/
Replacement
l A IMPORTANT I
ELEMENT REPLACEMENT INFORMATION I
This water heater isequipped with a special element
that has I%" threads. Make sure that the replace-
ment element has I_ threads.
I" DIAMETER lY*" DIAMETER
THREADED CAP THREADED CAP
3. Attach a hose to the water heater drain valve and put the
other end in a floor drain or outdoors. Open the water heater
drain valve. Open a nearby hot water faucet which will relieve
pressure in the water heater and speed draining.
O-RING GASKET
(1_" ELEMENT
ONLY)
NOTE." These instructions are written for element deanlng
and element replacement for the lower element. ][fit is neces-
sary to clean or replace the upper element, thee repeat these
instructions.
To remove the element from your tank in order to clean or
replace it:
1. Before beginning turn "OFF" the electric power supply to the
water heater.
AWARNING I
The water passingout ofthe drainvalvemay beextreme-
ly hot. To avoid beingscalded,make sure all connectionsI
are tight and that the water flow is directed away from
anyperson.
4. Remove the two screws securing the access panel, and remove
panel.
AWARNING
HAZARD OF ELECTRICAL SHOCK! Before removing I
any access panels or servicing the water heater, make
I sure the electrical suppl.yto the water heater is tumed I
"OFF". Failure to do thin could result in DEATH, SERI-I
I OUS BODILY INJURY,OR PROPERTY DAMAGE. I
2. Turn off the water supply to the water heater at the water
shutoffvalve or water meter.
18
5. After you have removed the lower access panel, remove the
adjustment dial from the thermostat by gently pulling it
directly away from the thermostat.
6. Open the flap of insulation to expose the opening.
. 14