Filter
Top Products
Installation Instructions (cont'd)
Installation Checklist
• Whether or not the element conversion is made, the model
raring plate must be marked• Using a hard point ink pen,
check the appropriate block within the model rating plate,
which is located adjacent to the lower access panel.
• Is the fuse or circuit breaker size correct as shown in the chart
in the "Product Specifications" section?
• Are the wires from the circuit breaker or fuse service to the
water heater's junction box on the correct wire size (gauge) as
shown in the chart in the "Product Specifications" section?
• Is the new temperature-pressure relief valve properly installed,
and piped to an adequate drain? See Temperature-Pressure
Relief Valve" section.
• Is the water heater completely filled with water? See _Filling
the Water Heater" instructions in the _Installation
Instructions section.
• Will a water leak damage anything? See "Facts to Consider
About the Location" section•
• Are the cold and hot water lines connected to the water heater
correctly? See "Water Piping" instructions in the "Installation
Instructions section•
• Is there adequate clearance for maintenance around the water
heater?
• Do you need to call your electric company to check your
wiring?
HOT COLD
TEMPERATURE.
PRESSURE
RELIEF VALVE
DISCHARGE
PIPE
(Do not cap or
plug)
6" AIR GAP
FLOOR DRAIN
MODEL RATING PLATE
15