Filter
Top Products
Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List_ Use this list to verify that
you have received all the components of
your new Kenmore vacuum.
R
WARNING
Electrical Shock Hazard
Do not plug into the electrical sup-
ply until the assembly is complete.
Failure to do so could result in elec-
trical shock or injury.
HANDLE ASSEMBLY
Remove the screw located just below the
top edge of the back of the vacuum.
Position the handle as shown in the illustra-
tion below,
While holding the power cord out of the way,
slide the handle into the opening at the top
of the vacuum°
Hand_
Handle
Screw
Hole
Insert the screw so it passes through the
handle into the vacuum°
Begin to tighten the screw with your fingers.
It may be necessary to adjust the handle
slightly,