Filter
Top Products
Although the dirt sensor feature in your
Kenmore Power-Mate ®is designed for years of
trouble free use, the passage of dirt through
the air passage system can coat the lens
causing the green light to come on and stay
on - never switching to red. When this happens
the lens must be cleaned.
CAUTION
Never use water or any cleaning
solution when cleaning the lenses. The
residue of the water or cleaners will
accelerate the recoating of the lenses
and make cleaning necessary sooner.
TO CLEAN
THE LENSES
1. Remove the
wand by pressing
the quick release
pedal and lifting
up on the wand.
2. As indicated by
Cross Section View
.f
p_ox.
3 N inches
or 90 mm
_ Ring
the illustration, the two dirt sensor elements
are located on the inside of the swivel, approx-
imately 3½ inches/90 mm down, (note the
arrows). Each element should be cleaned peri-
odically.To reach the sensor elements, use a
small brush such as a bottle brush. Brush
each sensor element several times to remove
dust and dirt.
NOTE: Looking down inside the swivel you will
see a ring.The sensor elements are located
just slightly below this ring.
3. Reinstall the wands after cleaning the sen-
sors.
TO REMOVE BELT
\
1. Turn Power-
Mate ® upside
down.
2. Unscrew the
two (2) Power-
Mate ® cover
screws.
3. Turn Power-
Mate ® right
side up. Press
handle release
pedal and
lower the
swivel. Lift
rear latches
up.
Side ear
Latch Latches
4. To remove cover,
grasp the sides and pull
out.
5. Lift agitator
assembly out
and remove
worn belt.
6. Check and
clean end cap End Cap
areas. See
AGITATOR ASSEMBLY for picture of
complete agitator assembly.
Base
t8