Filter
Top Products
English BR VS 400 *USA 6
Install the tank
Place the tank on the cleaner
OPERATION
Fill the tank
Note:
Observe the dosing
recommendations of the cleaning
agent's manufacturer and mix the
cleaning agent solution thoroughly.
Take care when handling cleaning
agents!
*
Comply with the safety
recommendations of the cleaning
agent's manufacturer
*
Rinse splashes in eyes or on the
skin out or off with plenty of clean
water
*
Call a doctor immediately
*
Wash contaminated clothing with
water
Open the cap
Fill the tank with the required amount
of fresh water
Note:
The maximum water temperature
must be 50°C.
–
Place the tank onto the cleaner
–
Check that the tank is positioned
correctly
Fill the tank with the required amount
of cleaning agent
–
Close the catch
–
Use a cloth to wipe away excess
liquid that pours out
–
Mix the cleaning agent well
Fitting the plug
Connect the plug to the power cable
–
Hang the power cable in the strain-
reliever
–
Plug the cable into the power
socket
Set the splash guard
–
Undo the fastening screw
–
Set the splash guard according to
each application.
–
Tighten fastening screw.
Note:
Adjust the splash guard parallel to the
floor
Turning the pushing handle
–
Press the pushing handle
downwards and turn to the LEFT or
RIGHT
–
Release strain on the pushing
handle and turn, it locks in several
positions