Kambrook KRH500 Electric Heater User Manual


 
19. Use this heater only as described in
this instruction manual.Any other use not
recommended by the manufacturer may
cause fire, electric shock or injury and
voids all warranties.
20.Always move the heater with the
handle provided.
21. Regularly inspect the supply cord, plug,
control settings, air inlets and outlets and
main housing for any damage. If found
damaged in any way, immediately cease
use of the heater and return to
Kambrook or an authorized service agent
for inspection.
22.The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA
be installed in the electrical circuit. See
your electrician for professional advice.
HOW TO OPERATE
1. Remove your heater from its carton,
unwind the cord to its full length.
2. Remove any element supports Guards
(ie foam or paper packing) by removing
the front guard screws , lift the guard
outwards, support and remove element
supports. Return the guard to the normal
position and replace screws.
3. Remove the warning sticker from the
front grill.
4. Read and follow the complete
instructions before plugging the unit into
the 230-240 Volt supply.
5. Place the heater on a level surface in a
stable position. Make certain the heater
element control switch is in the OFF
position.
6. Plug the power cord into a 240Volt
outlet, the red indicator light will
illuminate when the power outlet is
switched on.
7. Use the switch settings on the top
housing of the heater to switch the heater
to the desired setting.
NEVER OPERATE THE HEATER
WITHOUT THE FRONT GRILL
SECURELY IN POSITION.
Temperature Settings
1.The heater has 3 heat settings.
2.The heater has a Turbo fan setting that
will assist in distributing heat around the
room quicker.
Note:
Ther
e is a tip o
ver s
witc
h on the base.When
the heater tips over, it will turn off automatically.
4