Filter
Top Products
9
1. Locate the three brackets at the
back of the heater. There are
two brackets at the left and right
hand bottom corners, and one
situated at the top of the heater
in the centre.
2. As a general safety guide select
a suitable location to wall mount
the heater, approximately
500mm from any furniture either
side of the unit and 500mm from
any furniture placed in front of
the heater. The heater must be
mounted horizontally as per Fig. 1.
3. When selecting a location, make
sure the base of the heater is at
least 500mm from the floor and
the top of the heater is at least
1.5m from the ceiling to ensure
there is adequate air flow into the
air inlet.
4. Measure out and mark the
screw locations. Once you
are confident that the screw
locations are correct, drill suitable
size holes.
5. Take care with inserting the
screws into the holes you have
made, and then mount the
heater onto the screws.
6. Once the heater is mounted on
to the wall, screw in the locking
screw (the shortest screw) to
prevent the heater from being
accidentally dislodged from the
mounting bracket.
7. Visually inspect the air inlet
and outlet to ensure no foreign
material is blocking these areas.
CAUTION: Do not
mount the heater
below curtains and/or
other flammable items.
CAUTION: If the heater
is intended to be
used in a bathroom,
the heater is to be
installed so that
switches and other
controls cannot be
touched by a person
in the bath or shower.
KPH200_IB_Issue1,10.indd 9 4/12/09 2:01 PM