Filter
Top Products
4 5
5. Then simply reinsert the filter pouch into
the filter bracket (which is sitting in the
dust cup)
6. Place the dust cup back into the hand vac
unit by fitting the grooves in the dust cup
onto the locks of the unit.
7. Twist the dust cup in an clockwise
position until you hear a click.
8. Place the unit back onto the charging base
to charge up for its next use.
CARE AND MAINTENANCE
Thoroughly cleaning the dust cup and filters on
a regular basis will improve the performance of
the unit.
To clean the outside of the unit, wipe the
exterior with a soft, damp cloth. Never use an
abrasive cleaner.
Empty the dust cup on a regular basis. Clean
the filters on a regular basis.
To clean and replace filters
Filters must be cleaned from time to time to
remove the fine dust particles that have been
collected.
1. Remove the filter pouch, followed by the
filter bracket by lifting them vertically from
the dust cup.
2. Shake and tap the filters until all the fine
dust particles are removed.
3. The filter pouch and filter bracket can be
rinsed in luke warm water. Ensure you
let the filter pouch and filter bracket
completely dry naturally before next use.
4. To place the filters back in the dust
container firstly return the filter bracket
directly into the dust cup.
CLEANING THE DUST CUP AND
FILTERS
Dirt and debris picked up by your vacuum will
collect in the dust cup. The dust cup should be
emptied when full.
To empty the dust cup:
Always switch the appliance off prior to
replacing filters or emptying the dust cup.
To remove the dust cup locate the release
button situated half-way along the underside of
the hand vac. With one hand press the release
button in an upward direction.
With the other hand hold onto the dust cup
and turn in a anti-clockwise direction until the
dust cup is released and then lift upwards.
To empty the dust cup simply remove the two
filters and empty the dirt and debris straight
into a bin.
IMPORTANT: DO NOT USE THE UNIT
WITH OUT A DUST CUP OR FILTERS IN
PLACE
USING YOUR KAMBROOK
JAGUAR HAND VAC
Remove all packaging from the unit.
Ensure that the dust cup and filters are
correctly fitted.
Please charge the battery for 16 hours before
first use.
To commence vacuuming, remove the hand vac
from the charging base.
Push the on/off button, at the top of the
unit in an upward direction to switch
the unit on. You must leave your finger
in the ‘on’ position when vacuuming.
When vacuuming is complete, push down on
the ‘on/off’ button to the “off” position. Place
the unit immediately back on the charger after
each use.
ALWAYS ENSURE THAT THE DUST
CUP AND THE FILTERS ARE CORRECTLY
FITTED. NEVER OPERATE WITHOUT THE
DUST CUP AND FILTERS IN PLACE.
CREVICE TOOL
The crevice tool is ideal for vacuuming hard to
reach places such as the edges along skirting
boards, the crevice of car seats and corners.
Simply extend the crevice tool from the unit by
pulling the crevice tool away from the unit.
To retract the crevice tool, press the release
button under the nozzle and push the crevice
back into the unit.
KHV100_V2.indd 4-5 22/5/07 2:50:58 PM