Filter
Top Products
8 9
Using Your Upright Fan Heater
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into
the same circuit as your heater,
when it is in use.
Setting the Heating Mode
To control the heater, turn the Heat
Setting dial as follows.
The Heat Setting dial has 4 modes:
O - Shuts off the heater and fan
- For fan only operation
I - Low heat setting (1200 watts)
II - High heat setting (2400 watts)
Turn the heater off by turning the
Heat Setting dial to the ‘0’ position.
NOTE: This heater features a
tip-over switch. If the heater tips
over, it will automatically switch
off. Once placed back into the
upright position, the heater will
automatically switch on again.
ThermoGuard Overheating
Safety Device
Your heater is fitted with a safety
device that switches off the heater
in the event of overheating. Should
this heater stop working, turn off the
heater and inspect the air inlet and
outlet for blockages. Wait at least five
minutes for the protection system to
reset before attempting to restart
the heater.
If the heater fails to operate or the
safety device switches off again,
return the heater to your nearest
Kambrook service centre for
examination or repair.
Before First Use
Remove any promotional material
and packaging from the heater.
Unwind the cord to its full length
and place the heater on a firm, level
surface in a stable, upright position.
Visually inspect the air inlet and outlets
to ensure there are no blockages.
Turning Your Heater On
Ensure the Heat Setting dial is turned
to ‘0’ for OFF position.
Plug the cord into a 230V or 240V
power point and switch on.