Filter
Top Products
4 5
Do not run the cord under carpeting or
cover the cord with rugs, runners or the
like.Arrange cord away from traffic areas
and where it will not be tripped over.
To disconnect heater turn control to
OFF then switch off at the power outlet
then remove plug from its outlet.
Do not insert or allow foreign objects to
pass through the inlet or outlet openings,
this may cause an electric shock, fire or
damage the heater.
To prevent a possible fire, allow ample
space around the heater (at least1.7m at
front and 0.5m at the rear, top and sides)
and do not block air inlets or outlets in
any manner. Check the openings from time
to time for accumulated dust. Ensure long
shag carpet does not obstruct airflow
under unit.
Do not touch hot metal surfaces.
Switch off at control switch and power
outlet, then Unplug and allow heater to
cool down before cleaning or storing.
Use this heater only as described in this
instruction manual.Any other use not
recommended by the manufacture may
cause fire electric shock or injury and
voids all warranties.
HOW TO OPERATE
1. Remove heater from its carton and
unwind the cord to its full length.
2. Place heater on a firm level surface,
in a stable upright position.
3. Make sure the Selector Knob is turned
to OFF “O”.
4. Plug the cord into a 230-240V ac power
outlet.To avoid an electrical circuit
overload, be sure that no other appliances
are plugged into the same circuit with
your heater.
5. Control the heater with the Selector
Knob, as follows:
The Selector Knob has 4 settings:
Shuts off both heater and fan
Turns fan on and gives cool air
Gives warm air with half
heating power
Gives hot air with maximum
heating power
Note: There is a tip over switch on the base.
When the heater tips over, it will turn
off automatically.
FAN/HEAT SELECTOR
OVERHEATING
SAFETY DEVICE
Your heater is fitted with a safety device
that switches off the heater in the event
of overheating. Should the heater stop
working, turn the heater off and inspect
for blockage of air inlet or outlet.Wait
at least 5 minutes for the protection
system to reset before attempting
to restart the heater.
If the heater fails to operate or the safety
device switches the heater off again, return
heater to your nearest service centre for
examination or repair.
CARE AND MAINTENANCE
1. Always turn off and unplug the heater
before cleaning.
2. Use only a clean, dry cloth to clean the
external surfaces of the heater only.
3. If the heater has collected dust or dirt
inside the unit or around the element,
have the unit cleaned by a qualified
service agent. Do not operate the
heater in this condition.
4. Do not attempt to open the case of
the heater at anytime, there are no
customer serviceable parts inside.
5. When not in use, pack the heater in
its original box for best protection and
store in a cool, clean and dry location.