Filter
Top Products
8
Using Your Kambrook Arctic Remote Controlled
Tower Fan continued
To Operate the Arctic
Remote Controlled
Tower Fan
Plug the cord into a 230V or 240V
power point and switch on.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into the
same circuit as your fan, when it
is in use.
To turn the fan on simply press the
POWER button.
The Arctic Tower Fan has three fan
speed settings;
(LOW), (MED) and
(HIGH).
Press the Fan Speed button once for
LOW speed, a second time for MED
and a third time for HIGH. The fan
speed selected will be displayed on
the LCD screen.
To turn the fan off, simply press the
POWER button.
Your Arctic Tower Fan also features a
NATURE and REDUCTION setting.
Fig. 3
Setting the Oscillation
The oscillation function works in all air
flow settings.
Press down the Swing button to
activate. The fan will begin to
oscillate from side to side.
Press the Swing button again to stop
the fan from oscillating.
Setting the Timer
The Arctic Tower Fan incorporates an
eight hour, count down timer, which
allows you to set the fan to turn off
after 1, 2, 4 or 8 hours.
Press the Timer button once to
activate the timer setting. The timer
will then be set to turn off in 1 hour
and 1h will appear on the LCD screen.
Press the Timer button again, to have
the fan switch off after 2 hours, and
2h will appear on the LCD screen.
Similarly, pressing the Timer button
a 3rd or 4th time will set the fan to
switch off after 4 or 8 hours, and the
relevant setting will appear on the
LCD screen.
STOP
1 hour 2 hours 4 hours 8 hours
Using the Nature and
Reduction Settings
Both the NATURE and REDUCTION
settings can be used on any fan
speed. The LCD screen will indicate
what mode the fan has been set in.
The NATURE mode simulates the
natural rise and fall of the wind
over time.