Filter
Top Products
6
Using Your Kambrook Arctic Pedestal Fan
Before First Use
Remove any promotional material from
the fan.
IMPORTANT: When
unpacking the fan, check
to see you have received
all the items listed in the
Parts List, before discarding
the packaging.
Assembling Your Arctic
Pedestal Fan
Base and Pedestal Tube Assembly
1. Remove the four screws from the
criss-cross bars, and align these
four holes with those on the flange.
Secure the flange to the criss-cross
bars with the four screws. This might
require a bit of force.
Fig. 1
2.
Loosen the Height Adjustable Ring
and extend the support tube. A bit
of force may be required to grasp
the support tube, located inside the
Pedestal Extension Tube. Retighten
the Height Adjustment Ring to
prevent slipping.
3. Place the motor head housing onto
the Pedestal Extension Tube.
4. Tighten the screw to secure the
Pedestal Extension Tube to the
motor head housing.
Fan Head Assembly
1. Remove the Blade Cap from the
Motor shaft by turning it clockwise,
and then remove the Guard Locking
Nut by turning it anti-clockwise.
2. Thread the Motor shaft through
the centre hole of the Rear Grille,
placing the Rear Grille into position.
Make sure that the carry handle, on
the back of the Rear Grille is located
above the motor housing. Ensure
the Rear Grille is aligned with the
locating pins and fix the grille into
position by replacing the Guard
Locking Nut. Make sure that the Rear
Grille has not slipped off the locating
pins before tightening. This should be
done by hand. Do not force.
NOTE: When positioning the
Rear Grille on the Motor shaft,
always ensure the carry handle
on the grille is positioned in the
upright position.
3.
Insert the Plastic Blade onto the
Motor shaft, and match the pin slots
in the blade with the Motor shaft pin.
4. Fix the blade into place by
tightening the Blade Cap onto the
Motor shaft in an anti-clockwise
direction. This should be done by
hand. Do not force.
5. Unlatch the Securing Clips on the
Front Grille and unscrew the small
screw located at the bottom of the
front guard.
6. Press together the Front and Rear
Grille, and secure by snapping shut
the Securing Clips over edges of
both grilles. Make sure that the small
holes at the bottom of both grilles
are aligned. Tighten the Securing
Clips by hand.
7. Thread the screw through the
small holes of both the front and
back grilles, and tighten using the
nut provided.