Kambrook KCF200 Electric Heater User Manual


 
9
Setting the Heating Mode
CAUTION: DO NOT COVER
SWING
HIGH
MODE OFF LOW
30
0 MINS
60
90
120
150
TIMER 180
ON
To control the heater, turn the MODE
dial as follows.
The Heat Setting dial has 3 modes:
OFF - Shuts off the heater
1 - Low heat setting (500W)
2 - High heat setting (1000W)
Once the heat setting has been
selected, turn the TIMER dial to the ON
position. This will activate the heater.
NOTE: The Carbon Tower Heater
will not activate while the Timer
dial is set at 0 MINS.
To switch the heater off, turn the
MODE dial to the OFF position.
NOTE: This heater features a tip-
over switch. If the heater tips
over, it will automatically switch
off. Once placed back into the
upright position, the heater will
activate again.
Setting the Auto-Off Timer
The TIMER function works in all
operating modes, and switches the
unit off after a preset number of hours.
Turn the TIMER dial to activate the
timer settings. The timer can be set for
up to 3 hours.
For setting times less than 1 hour, turn
the timer dial past the 2 hours mark,
then turn back to the desired time.
The unit will then switch itself off after
the selected time has passed.
By turning the TIMER dial to ON, this will
ensure the heater runs continuously,
and will not turn itself off.
Setting the Oscillation
The oscillation function works in all
operating modes.
Press the SWING button once to
activate. The heater will begin to
oscillate from side to side.
Press the SWING button again to stop
the heater from oscillating.
KCF200_IB_V4.indd 9 21/10/09 9:34 AM