9
NOTE: This heater features a
tip-over switch. If the heater
tips over, it will automatically
switch off. Once placed back
into the upright position, the
heater will be in standby mode,
and the settings will need to be
selected again.
Setting the Variable
Temperature
The variable temperature can
be used to maintain your desired
temperature.
NOTE: The variable
temperature only operates
when the heater is being used
in the Auto mode.
Press the MODE
M
O
D
E
button until the
heater is set to AUTO mode.
The LCD screen will display the default
temperature of 25°C and will flash.
When the temperature is flashing,
you may set the desired temperature
using the VARIABLE TEMPERATURE
T
E
M
P
E
R
A
T
U
R
E
DIAL on top of the unit.
To adjust the set temperature rotate
the VARIABLE TEMPERATURE
T
E
M
P
E
R
A
T
U
R
E
DIAL
clockwise to increase the desired
temperature or anti-clockwise to
decrease the desired temperature.
The temperature can be set between
15° C and 35°C.
When the air temperature reaches
2-3°C above the set temperature,
the heater will automatically cut out,
although the fan will continue to run
for approximately 15 seconds to cool
the heater.
When the air temperature drops
below the set temperature the unit will
begin heating again.
Setting the Oscillation
The oscillation function works in all
operating modes.
Press the SWING
S
W
I
N
G
button once to
activate. The heater will begin to
oscillate from side to side.
Press the SWING
S
W
I
N
G
button again to
stop the heater from oscillating.
Setting the Auto-Off Timer
The timer function works in all
operating modes, and switches the
unit off after a preset number of hours.
Press the TIMER
T
I
M
E
R
button to activate
the timer settings. A timer symbol
will appear on the LCD screen
displaying 1 hour.
Press the TIMER
T
I
M
E
R
button to cycle
through the one hour increments, up
to 8 hours. The unit will then switch
itself to standby mode after the
selected number of hours has passed.
KCE440_IB_FA.indd 9 12/10/09 2:26 PM