Filter
Top Products
4
USING YOUR KAMBROOK JAGUAR
VACUUM CLEANER
When unpacking the vacuum cleaner unit
check to see you have received all the
required components, such as the hose
and other accessories before discarding
the packaging.
Ensure that the dust container and filters are
correctly fitted.
Locate the crush proof hose and push
the connection point into the hose inlet
connection on the front side of the unit, until
a “click” sound is heard.
Connect the wide end of the metal wand to
the hose end, and push together firmly.
Fit the floor tool to the narrow end of the
wand and push together firmly.
Fully extend the power cord by pulling the
power plug (situated at the rear of the unit)
out from the unit, until the yellow tape on the
cord is shown.
ENSURE THAT YOU DO NOT OVER
EXTEND THE POWER CORD – DO NOT
EXTEND PAST THE RED WARNING TAPE
ON THE CORD
Plug into a 230/240v power point and switch
the power on.
To commence vacuuming push down on the
on/off button at the top of the unit.
When vacuuming is complete, push down on
the ‘on/off’ button to switch off. Turn the
power off at the outlet and then remove the
power cord from the power outlet. When
removing plug from the power outlet grasp
the plug not the cord.
To retract the cord push down on the ‘cord
rewind’ to retract the cord.
IMPORTANT: HOLD THE PLUG END
WHEN RETRACTING THE CORD TO
PREVENT IT FROM STRIKING YOU OR
THE VACUUM.
CAUTION: ALWAYS ENSURE THAT
THE DUST CONTAINER AND THE MOTOR
PROTECTION FILTER ARE CORRECTLY
FITTED. NEVER OPERATE WITHOUT
THE DUST CONTAINER AND FILTERS
IN PLACE.
CLEAN THE FLOOR TOOLS SECTION
REGULARLY REMOVE HAIR, COTTON ETC
FROM THE TURBO BRUSH HEAD. CUT
ACROSS THE HAIR ETC AND GENTLY
PULL FREE.
VARIABLE POWER CONTROL
The power booster dial on the unit is to be
used for variable power control. Turn the
control clockwise for maximum power for
vacuuming hard floor and carpet surfaces.
Turn the control anti-clockwise for
minimum power when using the crevice
and brush tools.
TURBO BRUSH
The Turbo Twister Brush is a floor tool
which has been specifically designed to work
in conjunction with your KBV70 Jaguar Turbo
Twister Bagless Vacuum Cleaner. While
regular floor tools do a good job at cleaning
surfaces the Turbo Brush is the ideal way to
clean away those hard to see dust and dirt
particles that are trapped deep within carpet
pile.
Fit the Turbo Brush onto the telescopic wand
and follow the regular starting procedure and
commence vacuuming. The suction of the
cleaner starts a curved row of bristles in the
brush rotating at high speed. These rotating
bristles actively work to dislodge deep pile
debris to provide a more effective surface
clean.
The Turbo Brush has been specifically
designed for removing dirt and debris from
carpeted surfaces. Do not use it for any
purposes, other than those stated. For
optimal performance of your Turbo Brush
ensure that the bristles are kept clean after
use.