Filter
Top Products
12
Shake and tap the cone until
all the fine dust particles are
removed. The cone can also be
hand washed. Allow the cone
to completely air dry before re-
assembling.
To replace the cone into the dust
container, grip the two pockets
at the base of the cone with two
fingers, slide the cone into the
allocated bracket inside the dust
container and twist clockwise to
‘CLOSE’ until resistance is felt.
Fig. 15
7. Place the dust container back in
the vacuum cleaner for next use.
NOTE: If the Canister does not
easily fit in position, the filter
casing may be in the wrong
orientation. Do not force the
dust canister back into position.
Care and Maintenance continued
IMPORTANT: Dirty
and clogged filters
may result in reduced
suction performance. It
is recommended that
filters are cleaned after
every use and replaced
regularly to ensure
maximum efficiency from
your vacuum.
Exhaust filter
The exhaust filter should be cleaned
every six months. Simply unclip
the grill on the top of the vacuum
cleaner towards the rear, shake and
tap the filter to remove any dust
accumulated. Then relocate the filter
and reattach the grill.
NOTE: Always switch the
vacuum off, then switch off at
the power outlet and unplug
the appliance prior to cleaning
or replacing either filter.
To clean the outside of the
unit, wipe the exterior with a
soft, damp cloth. Never use an
abrasive cleaner.
IMPORTANT: Check and
replace both the motor
protection and HEPA
filters approximately
twice a year or when
visibly clogged.
KBV250-220-280_IB_B11.indd 12 23/08/11 10:12 AM