JVC SP-UXP400 Gas Heater User Manual


 
9
English
Listening to the Radio
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency stops changing.
When you repeatedly press the button, the frequency changes
step by step.
To stop searching manually,
press either button.
If the received FM station is hard to listen
To preset the stations
You can preset 30 FM and 15 AM stations.
1
Tune in to a station you want to preset.
You can also store the monaural reception mode for FM
preset stations if selected (see above).
2
Activate the preset number entry mode.
Finish the following process while the indication on the
display is flashing.
3
Select a preset number for the station you store.
You can also use the PRESET UP/PRESET DOWN
buttons.
4
Store the station.
Remote control: Main unit:
The MONO indicator lights on the display.
Reception will improve though stereo
effect is lost—Monaural reception mode.
To restore the stereo effect,
press the
button again (the MONO indicator goes
off).
FM AM
2 sec.
2 sec.
DOWN
UP
Remote
ONLY
FM
MODE
Examples:
To select preset number 5, press
5.
To select preset number 15,
press +10, then 5.
To select preset number 30,
press +10, +10, then 10.
Remote
ONLY
SET
1
4
7
10
2
5
8
3
6
9
10
SET
Basic.fm Page 9 Monday, February 16, 2004 10:59 AM