Filter
Top Products
8
INSTALLATION
Wall Mount or Ceiling Mount — you will need:
- Drill
- 3/8" Drill bit (if running cable thru wall or ceiling)
- 1/8" drill bit (for drilling screw pilot holes if mounting
into wood or non-brick material)
- 3/16" drill Bit (for drilling holes for plastic anchor s if
mounting onto drywall or brick material)
- a screwdriver.
- Adjustment wrench (included)
Step 1. Mounting preparation
Once a suitable location for the
camera has been selected and
the cable route has been
determined, you will need to use
the camera’s mounting bracket
as a template to mark holes for
drilling. Mark three holes on the
wall for the anchors or screws as shown. Please take
care to mark the center of the holes.
Note: Before mounting camera permanently,
check to ensure the appropriate channel has been
selected (see Channel Selection) to provide good
reception at the receiver/monitor.