Filter
Top Products
Jacuzzi Whirlpool Bath: Shower Towers Page 14 FZ71000C • 10/07
PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.
Jacuzzi Whirlpool Bath has obtained applicable code (standards) listings generally available on a national basis for products of this
type. It is the responsibility of the installer/owner to determine specic local code compliance prior to installation of the product.
Jacuzzi Whirlpool Bath makes no representation or warranty regarding, and will not be responsible for any code compliance.
Jacuzzi Whirlpool Bath
14525 Monte Vista Avenue
Chino, California 91710
Customer Service: Call: 1-800-288-4002
Proper installation of the shower tower and compliance with local codes is the responsibility of the installer. Jacuzzi Whirlpool Bath
does not warrant connections of water supply ttings and piping, or ll systems. Nor is it responsible for damage to the shower tower
which occurs during any installation procedure.
1. CONTROL VALVE. The Control Valve consists of three parts, the diverter (20a),
ow control (20b), and thermo-static control (20c).
a. Diverter
The Diverter (20a) works as a function selection. Four icons on the diverter
indicate the function selected. The four icons represent the following four
functions: Hand shower spray , Body jets , Wall mount spray , and
Bath spout .
b. Flow Control
The Flow Control (4b) is located in the center of the Control Valve and is used to
control the water ow volume. Increase the water ow by turning the handle to the
left and decrease by turning to the right.
c. Thermo-Static Control
The thermo-Static Control (20c) is used for setting the water temperature. There are
the “H” and “C” letters, and red and blue colors representing Hot and Cold, respectively.
Users can adjust the water temperature as they want by turning the control handle.
CAUTION: The “38° C” (100° F) mark on the control represents the safety temperature level. If a higher
water temperature is needed, turn the handle left while pressing the red button.
CAUTION: Remember to return the handle to the “38°C” after use at the higher water temperature.
2. BRACKET. Use the wall mounted bracket (16) to hold the hand shower (15) on wall. Select "??" on the Diverter
to activate the hand shower.
Troubleshooting
1. If the water ow rate is reduced or if there is no water ow while using a specic function, dismount the shower
tower and verify the main water supply hoses (blue and red supply lines) or tubing are not bent or kinked.
2. During operation, if only cold or hot water is supplied but no combination, please check to see if the thermo-static
control (20c) is set at the middle level. Also check for bending or kinking in the main cold or hot water supply
lines.
Cleaning
Do not use sand paper, thinner or other corrosive cleaner. Normal non-abrasive household cleaners can be used.
Rinse with water.
38
20a
20b
20c
OPERATION