Filter
Top Products
4
5. Installation
1. When making electrical connections it is always recommended that the vehicle’s
battery be disconnected from the electrical system before performing the installation.
2. Carefully remove the trim panels covering the 10mm bolts that secure the radio into
the dash cavity. Remove these bolts, and carefully pull the radio from the dash of the
vehicle. This will provide access to the factory radio connectors where you will
connect the Media Gateway harness.
3. Disconnect the factory 12-Pin harness (if present) from the back of the radio.
Disconnect the antenna from the radio.
4. Connect the 8-Pin iPod docking cable into the rst port on the Media Gateway
(farthest away from dipswitches). Carefully run the 11 foot iPod cable behind the dash
to the location where the iPod will be mounted or stored (for example the glove box
or center console). This location will vary based on the vehicle, and the customer’s
prefrence. When running this cable through the dash be sure to secure it away from
moving parts or sharp metal edges that may damage the cable.
5. If connecting the HD Radio Tuner (HDRT sold separartely), make the folllowing
connections before connecting the PXAMG to the vehichle. Plug the 3 foot HD
Radio Cable (8-Pin mini-din to 8-Pin mini-din) cable into the second port (closest to
the dipswitches) on the Media Gateway. Connect the other end of this cable into the
HD Radio tuner. Connect the factory antenna cable into the antenna connection on
the HD Radio tuner (HDRT).
NOTICE:
After removing the radio, if there are two antenna leads connected into the back
of the radio, your vehicle is equipped with a diversity antenna system. When
connecting the HDRT follow these steps to provide ensure the best performance
of the HD Radio Tuner. If you do not feel comfortable making these connections
you will need to purchase the PGHTYHD harness (sold separately).
1. Locate factory Power antenna wire in radio’s wiring harness. This wire will be in Pin
location #18 (See Diagram)
2. Cut this wire about 2 inches from the back of the radio.
3. Carefully remove about ½ an inch of insulation from the wire on the VEHICLE’S
side. (Not the wire connecting into the radio)
4. Locate the accessory wire Pin location # 20 (See diagram)
5. About 2 inches away from the radio carefully remove about ½ an inch of insulation
from this accessory wire.
6. Connect the vehicle’s side of the Power antenna
wire(stripped) to the accessory wire. (solder this
connection to ensure the best connection possible)
7. Insulate this new connection on the Accessory wire
to prevent an electrical short