InSinkErator 152 Water Heater User Manual


 
5
PREPARATION
INSTALLATION PROCESS STARTS HERE
Ensure power switch located at the
front-top of tank is in off position.
Identify location for water heater tank.
Check to make sure there is proper
clearance in front of heater to allow
for draining the tank and for access
to replaceable parts such as the
thermostat, heater and relief valve.
Locate heater in an area where
leakage of the tank or connections
will not result in damage to the
area adjacent or to lower floors of
the structure.
When such locations cannot be
avoided, a suitable drain pan piped
to an adequate drain should be
installed under the heater (available
from your distributor).
1
A
B
Property Damage: If the heater becomes immersed in
water, the heater should be examined by a competent
service person before it is placed back in operation.
Equipment You May Need:
Equipment Required:
Adjustable wrench
Level
Pencil
Tape Measure
Phillips and flat blade screwdrivers
T & P valve
(Pre-installed on some models)
Support blocks
Drain pan
Teflon tape
WHAT YOU NEED TO GET STARTED
Personal Injury: Failure to follow these instructions can result in serious
personal injury or death.
The installation must conform to these instructions, the local code authority having jurisdiction
and the requirements of power company. In the absence of code requirements follow NFPA-70,
The National Electrical Code, which may be ordered from: American Standards Institute, 1430
Broadway, New York, NY 10018.
4
An imminently hazardous situation, which, if not avoided, will result in death or serious injury.
A potentially hazardous situation, which, if not avoided, could result in death or serious injury.
A potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
This heater must only be installed or serviced by qualified persons with ability equivalent to
that of a licenced tradesman in the field involved.
For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing
or using this water heater.
Unit must be installed indoors.
Make sure that all electrical wiring and plumbing connections conform to local codes. Consult local
code and national electrical code for proper installation.
This water hearter is an electrical device and must be properly grounded, fused and connected to the
correct line voltage. Connect only to properly grounded outlet (see page 10).
Install or locate this water heater only in accordance with the provided installation instructions. Do not
operate the heater in rooms, garages or other area
s where gasoline or other flammable liquids or
engine driven vehicles or eqipment are stored, operate or repaired. Flammable vapors are heavy and
travel along the floor and may be ignited by the electric heater causing fire or explosion.
Use this water heater only for its intended use as described in this manual.
This heater is a pressure vessel and must have a T & P (Temperature & Pressure) valve installed.
Do not use an extension cord set with this water heater. If no receptacle is available adjacent to the
water heater, contact a qualified electrician to have one properly installed.
Do not operate this water heater if it has a damaged cord or plug, if it is not working properly or if it
has been damaged or dropped.
Flammable items, pressurized containers or any other potential fire hazardous articles must never be
placed on or adjacent to the heater. Open containers of flammable material should not be stored or
used in the same room with the heater.
Protect heater from freezing. Water left in the tank allowed to freeze will expand and damage the tank.
Disconnect power and drain tank to prevent damage (see page 11).
Do not attempt to operate this heater with cold water shutoff valve closed. Disconnect power if shutoff
valve is closed.
This water heater should be serviced only by qualified service personnel. Contact nearest authorized
service facility for examination, repair or adjustments.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
When using electrical appliances,basic safety precautions to reduce the risk of fire, electric shock or
injury to person should be followed, including:
Keep this warranty and manual near the heater for future reference
whenever maintenance adjustment or service is required.
Definition of symbols in this instruction manual:
Minimum
Clearance
4"