Filter
Top Products
67165-XPage 2 of 4
67166-( ) SOLENOID KIT INSTALLATION
1”, 1-1/2” AND 2” NON-METALLIC DIAPHRAGM PUMPS
1” AND 1-1/2” METALLIC DIAPHRAGM PUMPS
Refer to figure 2.
1. Remove (105) bolts from air inlet end of (101) motor body and re-
move (107) leg / plate and (108) gasket.
2. Place 94641 taper plug in pilot hole of (101) motor body.
3. Replace (128) pipe plug on (101) motor body with 59756-4 fitting.
For 1" Metallic models only:
4. Drill a 1/4" (0.250) hole in (107) leg, using the template below.
5. Attach (108) gasket, modified (107) leg, 92878 gasket and CAT33P-(
)-( ) valve to (101) motor body, using Y6-44-C bolts and Y14-416-T
washers. NOTE: Torque to 40 - 50 in. lbs (4.5 - 5.6 Nm).
6. Connect CAT33P-( )-( ) valve with 59756-4 fitting, using
94981-XXX-X tube.
For all others:
4. Attach (108) gasket and CAT33P-( )-( ) valve to (101) motor body,
using Y6-44-C bolts and Y14-416-T washers. NOTE: Torque to 40 -
50 in. lbs (4.5 - 5.6 Nm).
5. Connect CAT33P-( )-( ) valve with 59756-4 fitting, using
94981-XXX-X tube.
Figure 2
~ 92878
~ Valve
(see table below)
.Torque to 40 - 50 in. lbs (4.5 - 5.6 Nm).
~ Supplied with 67166-( ) Kit.
Z See page 4 for coil options.
g 94981-XXX-X Bulk Tubing (100’ long).
128
59756-4 ~
107
~ 94641
TOP
TEMPLATE
1/4" Dia.
~ . Y6-44-C (4)
~ 59756-4
108
105
107
108
~ Valve
(see table below)
~ Y14-416-T (4)
~ . Y6-44-C (4)
1", 1-1/2" and 2" Non-Metallic and 1-1/2"
Metallic models (above heavy line)
1" Metallic models (below heavy line)
(Located on bottom of 1-1/2"
and 2" motor bodies.)
MODEL VALVE VOLTAGE
67166-1 CAT33P-024-D 24 VDC
67166-2 CAT33P-120-A 120 VAC
67166-3 CAT33P-000-N No Coil Z
~ 676
~ Y14-416-T (4)
~ 93911
~ 93911
~ 676
~ 59756-4
~ 94981-XXX-X
(6-1/16" long) g
~ 94981-XXX-X
(6-1/16" long) g
NOT SHOWN
CHW Connector
108